SAS 530

RAPID SET EPOXY ADHESIVE

PRODUCT INFORMATION

Alpha SAS 530 is a highly reactive two component epoxy adhesive in a twin syringe for easy, clean and accurate dispensing.

Alpha SAS 530 is suitable for bonding metals, glass, GRP, ceramics rubbers, plastics & wood. It is suitable for use in light assemblies, maintenance & repairs.

Alpha SAS 530 is resistant to water & a wide range of solvents.

KEY INFORMATION

  • Rapid cure

  • Easy to use

  • Accurate dispensing

  • Bonds to a wide variety of surfaces

  • Solvent Free

  • 1:1 mix ratio

TYPICAL APPLICATIONS

Alpha SAS 530 is suitable for the following applications:

  • Ideally suited for a wide range of electronic, electrical, industrial, structural, and jewelry applications
  • Light assemblies
  • Maintenance and repair work

PRODUCT CHARACTERISTICS

The following technical information and data should be considered representative or typical only. Therefore, the information should not be used for specification purposes.

PRODUCT PERFORMANCE

The performance data presented here has been determined by Alpha Adhesives & Sealants Limited standard test methods and are average values that should not be used for specification purposes. Our recommendations on the use of this product are based on tests believed to be reliable. It is advised that users conduct their own tests to determine the suitability of the product for their specific application.

HANDLING & APPLICATIONS

The general application information presented here is based upon typical conditions determined by Alpha Adhesives & Sealants Limited testing. Our recommendations on the use of this product are based on methods believed to be reliable. It is advised that users conduct their own tests to determine the suitability of the product for their specific application.

All substrate surfaces should be abraded using abrasion paper or air-driven narrow belt sander. It is imperative that the surfaces are then cleaned of any dust, grit, loose material, wax, grease and oil using a suitable cleaner such as Alpha T559.

  1. Dispense the desired amount of SAS 530 in to a suitable mixing vessel. Ensure that the correct mix ratio of resin to hardener is used (1:1).
  2. Mix the two parts together quickly until a uniform consistency is achieved.
  3. Apply the adhesive to one of the material surfaces that is to be bonded.
  4. Clamp the two material together until the handling strength is achieved 15 minutes after the adhesive has been mixed.

It is important that Alpha SAS 530 is mixed and used, and the materials clamped together before the pot life is exceeded.

Handling strength is achieved approximately 15 minutes after bonding. Full cure is achieved 24 hours after bonding.

A suitable solvent cleaner such as Alpha T559 should be used to clean uncured adhesive prior to curing.

When fully cured, Alpha SAS 530 will require mechanical sanding to remove material.

HEALTHY & SAFETY INFORMATION

Alpha SAS 530 is classified as hazardous according to Directive EC 1272/2008. Please refer to the Alpha SAS 530 Safety Data Sheet for further health & safety information.

STORAGE

Alpha SAS 530 should be stored in its original container, with the syringe cap tightly secured, in dry conditions and at temperatures between 5°C and 25°C. Alpha SAS 530 will keep satisfactorily for up to 12 months from date of manufacture if stored according to the recommended conditions.

PRODUCT AVAILABILITY

Product Reference
Pack Size
Container
Box Quantity
SAS 530 Part A
20 kg
Plastic Bucket
N/A
SAS 530 Part B
20 kg
Plastic Bucket
N/A
SAS 530 Part A
5 kg
Tins
N/A
SAS 530 Part B
5 kg
Tins
N/A
SAS 530 Kit
1 kg
2 x Plastic Tubs
N/A

ISSUE : 3

20/06/2018