S1589

LOW VISCOSITY NITRILE CONTACT ADHESIVE

PRODUCT INFORMATION

Alpha S1589 Nitrile Contact Adhesive has been developed for bonding soft, plasticized PVC and polyurethane materials to themselves or to metals and foams.

It can also be used as a general purpose adhesive for bonding wood, felt and many other substrates.

The adhesive film has very good resistance to oil and grease.

KEY INFORMATION

  • Low viscosity

  • Short open time

  • Ideal general purpose adhesive for bonding PVC and PU

  • Oil and grease resistant

TYPICAL APPLICATIONS

Alpha S1589 is suitable for the following applications:

  • Bonding soft, flexible PVC materials
  • Bonding polyurethane foams and fabrics
  • Bonding in medical testing devices

PRODUCT CHARACTERISTICS

The following technical information and data should be considered representative or typical only. Therefore, the information should not be used for specification purposes.

* dependent upon ambient temperature, relative humidity and the materials used.

PRODUCT PERFORMANCE

The performance data presented here has been determined by Alpha Adhesives & Sealants Limited standard test methods and are average values that should not be used for specification purposes. Our recommendations on the use of this product are based on tests believed to be reliable. It is advised that users conduct their own tests to determine the suitability of the product for their specific application.

HANDLING & APPLICATIONS

The general application information presented here is based upon typical conditions determined by Alpha Adhesives & Sealants Limited testing. Our recommendations on the use of this product are based on methods believed to be reliable. It is advised that users conduct their own tests to determine the suitability of the product for their specific application.

All substrate surfaces should be abraded using abrasion paper or air-driven narrow belt sander. It is imperative that the surfaces are then cleaned of any dust, grit, loose material, wax, grease and oil using Alpha T162 or a suitable cleaner.

TWO-WAY STICK

  1. Alpha S1589 Nitrile Contact Adhesive must be stirred carefully before use. Keep adhesive container
    closed whenever adhesive is not being used to reduce solvent evaporation.
  2. Apply a thin, even coating of Alpha S1589 to both surfaces to be bonded. Do not apply the adhesive to an area greater than can be covered in one day.
  3. Allow the solvent to evaporate before bonding the materials. The time for evaporation will
    depend on the temperature and humidity. Under normal ambient conditions this will take a minimum of 1-2 minutes and a maximum of 15 minutes or until the adhesive film no longer transfers to the fingertip. Join the surfaces.
  4. Bring the surfaces together and bond firmly taking care not to trap air, and use as much
    pressure as possible to consolidate the bond. Immediately brush down the bonded portion
    with a soft bristle push broom or a clean dry roller applicator to achieve maximum contact.
  5. Dried films of Alpha S1589 may be reactivated by wiping the surface with T162 solvent.

The immediate high contact bond strength increases appreciably within the next 48 hours and will develop still further in service. For the best heat resistance, leave at room temperature for 7 days, before subjecting to high temperatures

Alpha Cleaner T162 should be used to remove residues from surfaces.

HEALTHY & SAFETY INFORMATION

Alpha S1589 is classified as hazardous according to Directive EC 1272/2008. Please refer to the Alpha S1589 Safety Data Sheet for further health & safety information.

STORAGE

Alpha S1589 should be stored in its original container, with the lid tightly secured, in dry conditions and at temperatures between 5°C and 25°C. Alpha S1589 will keep satisfactorily for up to 18 months from date of manufacture if stored according to the recommended conditions.

PRODUCT AVAILABILITY

Product Reference
Pack Size
Container
Box Quantity
Alpha S1589
5 L
Tin
N/A

ISSUE : 3

January 2019